Table of Contents
Advertisement
Description of the ISW
1.1.5
Setup procedure
A. Connecting a PC
a.
Procedure
1. Loosen 4 screws [1] and remove the side
cover/2 [2].
[2]
2. Connect either of IEEE1284 port [1] or USB
(Type B) port [2] to the PC via a cable.
1
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
Note:
B. Power on mode
a.
[1]
[1]
8050fs2012
C. HELP + CHECK mode
a.
[1]
[2]
8050fs2040
2-4
• Before performing ISW via USB, be sure to
turn on the USB radio button in [Setting (S)] -
[Set Communication (C)] in ISWTrns and
press the OK button.
Procedure
1. Turn ON the sub power switch (SW2).
2. Check the timer LED is flushing.
The control program becomes possible to be
written in this state.
3. Execute the operation according to the proce-
dures specified in the "ISW (In-System Writer)
Service Manual."
Note:
• Do not turn OFF the copier while writing the
ISW data is being rewritten.
4. The operation screen appears if it is completed
successfully.
If it is terminated abnormally, see "E. The rela-
tionship between ISW resulting operation and
the operational LEDs."
Procedure
1. Turn ON the copie while pressing "HELP" and
"CHECK button."
2. "ISW write mode select menu screen"
Press 1 (PC) with the numeric keys.
ISW WRITE MODE SELECT MENU
1.PC
PLEASE PUSH TEN-KEY
9.EXIT
Advertisement
Table of Contents
