Table of Contents
Advertisement
OTHER ADJUSTMENTS
9.16 FNS adjustment of the angle
of the folding stopper (only
for FS-215/FN-9/FS-606)
Note:
• Never move the stapler unit in a horizontal
direction manually (it may cause teeth to skip
between the belt and gear).
• Never loosen the screw [1] that must not be
removed.
A. Procedure
1. Perform a folding operation with A3 paper to
check whether the discrepancy at the folding
edge is within the standard value.
Standard value: A = 1 mm or less
If the discrepancy is not within the standard
value, perform the following adjustment.
2. Open the finisher door and pull out the stacker
unit.
3. Remove the rail stopper screws for the stacker
unit. Then, pull out the stacker unit further.
Note:
• To avoid the finisher from falling, make sure
to place a support under the stacker unit.
4. Remove the stapler unit cover.
2
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
A
1-170
[1]
8050fs1106
8050fs1107
Advertisement
Table of Contents
