Table of Contents
Advertisement
OTHER ADJUSTMENTS
B. When some printouts are skewed:
1. Print the test pattern No.16 in the continuous
copy mode to check the skew amount.
2. Open the top cover [1].
3. Loosen 6 screws [2] at the top of LCT to loosen
the guide plate/front [3], the guide plate/rear [4],
and the guide plate/right side [5].
4. Tighten the 6 screws at the position where each
guide plate is in contact with paper.
Reference:
• The size indicator on the guide plate is
approximately 2 mm wider than the actual
standard size paper. It may cause the skew for
some paper. The skew amount is reduced if
paper is fixed with each guide plate in tight.
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
[3]
[2]
[5]
1-182
[2]
[4]
[1]
[2]
8050fs1067
Advertisement
Table of Contents
