Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
10. Rotate the gear [1] for the stapler downward.
Adjust the position of the clincher [4] for the
plate [2] attached to the cartridge to be inserted
into the slot [3] on the jig smoothly. Rotate the
gear [1] downward further. Then, place the plate
[2] onto the slot [3] on the jig and fully insert the
jig into the clincher unit [4].
11. Tighten 4 screws for each clincher.
12. Remove the jig by rotating the gear for the sta-
pler upward.
Note:
• Make sure not to snag on Mylar on the
clincher when removing the stapler position-
ing jig.
13. Remove the cartridge and plate. Then, replace
the staple sheet removed at the step 5. Replace
the cartridge.
14. Check the operation of the stapler.
[2]
1-167
OTHER ADJUSTMENTS
[1]
[3]
[4]
[1]
8050fs1102
Advertisement
Table of Contents
