Table of Contents
Advertisement
36 MODE
7.8.3 Cover sheet tray size adjustment (PI-110
only)
This adjustment should be performed when the
cover sheet tray size cannot be detected properly
and when centring adjustment for cover sheet tray
is performed.
A. Procedure
1. Enter the 36 mode.
2. "36 mode menu screen"
Press the [7. Finisher adjustment] key.
3. "Finisher adjustment mode menu screen"
Press the [3. Cover sheet tray size adj.] key.
4. Set a A4R (for metric machine) or 8.5 x 11R
(for inch machine) paper on the cover sheet
tray (upper/lower) [1] and press the [Start] key.
A complete message appears on the screen.
[1]
5. Press the [PREVIOUS SCREEN] key to return
to the "Finisher adjustment menu screen."
2
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
7.8.4 Trimming stopper adjustment (TU-109/
TMG-3 only)
Adjusting the trimming amount.
A. Procedure
1. Enter the 36 mode.
2. "36 mode menu screen"
Press the [7. Finisher adjustment] key.
3. "Finisher adjustment mode menu screen"
Press the [4. Trimming stopper adjustment]
key.
4. "Trimming stopper adjustment (A3) screen"
Press the [COPY SCREEN] key.
5. Set paper in the tray, set originals (more than 2
sheets) on RADF, and press the START but-
ton.
For the machine with platen cover, scan origi-
nals (more than 2 sheets) with [Store] key.
6. Check the trimming amount.
• Standard value: 2.5 to 4.5 mm
Note:
• Setting a trimming amount of 2.5 mm or
less may cause a trimming error.
7. When the value is not within the standard,
press the C button while pressing the P button.
8050fs1022
8. "Trimming stopper adjustment screen"
Press the [NEXT ADJUSTMENT] or [PREVI-
OUS ADJUSTMENT] key to select a desired
paper size.
9. Enter a numeric value through the numeric
keys and press the [SET] key.
• Setting range: -128 to +127, 1 step = 0.1 mm
10. Repeat steps 4 to 9 until the standard value is
obtained.
11. Press the [PREVIOUS SCREEN] key to return
to the "Finisher adjustment menu mode
screen."
1-108
Advertisement
Table of Contents
