Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
9.23 LCT paper feed roller pres-
sure adjustment
Perform the LCT paper feed roller pressure adjust-
ment when the no feed jam occurs at the paper feed
(when coated paper is being used).
Note:
• The piled plate kit (P/N: SE95-4330) is a sup-
ply part. It should be purchased separately.
A. Procedure
1. Open the top cover [1].
2. Remove the spring [2].
3. Install the piled plate holder [4] on the paper
feed roller [3] with 2 screws [5].
Note:
• The piled plate kit is accompanied with the 5
piled plates [6]. However, the number of the
piled plates [6] should be adjusted while
checking no feed condition. (When the piled
plates are too heavy, this may result in double
feeding.)
The piled plates [6] can be removed by loos-
ening the 2 screws [7].
4. Replace the spring [2].
5. Close the top cover.
6. Perform the continuous copy to check the paper
feed.
7. Repeat steps 1 to 6 if the no feed jam continues
to occur at the paper feed.
[3]
[1]
1-183
OTHER ADJUSTMENTS
[5]
[4]
[6]
[7]
[2]
8050fs1068
1
Advertisement
Table of Contents
