Table of Contents
Advertisement
OTHER ADJUSTMENTS
9.13 FNS adjustment of the sta-
pling position (flat stapling)
Note:
• Never move the stapler unit in a horizontal
direction manually (it may cause the teeth to
skip between the belt and gear).
A. Procedure
1. Perform a stapling operation to check whether it
is performed within the standard value.
• Standard value for the one-corner stapling (at
rear) [1]: A = 8.5 ± 3 mm
• Standard value for the one-corner stapling (at
front) [2]: B=8.5 ± 3 mm
• Standard value for the flat stapling [3]: C= B=8.5
± 3 mm
(In the flat stapling, the paper edge and the line [4]
connecting 2 staples must become parallel)
If not, perform the following adjustment.
2. Open the finisher door and pull out the stacker
unit.
3. Remove the rail stopper screws for the stacker
unit. Then, pull out the stacker unit further.
Note:
• To avoid the finisher from falling, make sure
to place a support under the stacker unit.
4. Remove the stapler unit cover.
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
[1]
[3]
[4]
1-158
[2]
8050fs1095
Advertisement
Table of Contents
