Chapter 29 Ip Commands; Ip Commands Introduction; Ip Settings And Default Gateway - ZyXEL Communications AAM1212 User Manual

This chapter shows you how to use the
parameters.

29.1 IP Commands Introduction

Use the AAM's management IP addresses to manage it through the network.

29.2 IP Settings and Default Gateway

Use the following command sequence to set the AAM's IP settings for the Ethernet 1 and 2,
and DSL ports, VID and default gateway. With the Ethernet 1 and 2, and DSL ports, you must
connect to the AAM through a port that is a member of the management (CPU) VLAN in
order to perform in-band management.
1
ras> ip set <new ip address> [</netmask>]
2
ras> ip gateway <ip>
3 ras> config save
where
<new ip
address>
</netmask>
<ip>
Line 1 changes the IP settings for the AAM's uplink, downlink and AAM DSL ports. If you
don't enter the subnet mask, the system automatically computes the subnet mask.
Line 2 changes the default gateway (next hop). This tells the AAM where to send packets that
have a destination IP address that is not on the same subnet as the AAM's IP address.
Line 3 saves the new configuration to the nonvolatile memory.

Chapter 29 IP Commands

C
ip
= The IP address you want to configure for the AAM.
= The bit number of the subnet mask of the IP address you want to
configure for AAM's uplink, downlink and AAM DSL ports. To find
the bit number, convert the subnet mask to binary and add all of the 1's
together. Take "255.255.255.0" for example. 255 converts to eight 1's
in binary. There are three 255's, so add three eights together and you
get the bit number (24).
= The default gateway IP address you want to configure for the AAM.
H A P T E R
IP Commands
commands to configure the IP (Internet Protocol)
AAM1212 User's Guide
2 9
243