Adsl Enable Command; Adsl Disable Command; Figure 109 Adsl Show Command Example - ZyXEL Communications AAM1212 User Manual

Figure 109 ADSL Show Command Example

ras> adsl show 1
port enable mode
---- ------ -------- ------------- -------------------------------
1
Subscriber Info:
port name
---- -------------------------------- ----------------
1 -

27.3.2 ADSL Enable Command

Syntax:
adsl enable <portlist>
where
<portlist>
This command forcibly enables the specified ADSL port(s).

27.3.3 ADSL Disable Command

Syntax:
adsl disable <portlist>
where
<portlist>
This command forcibly disables the specified ADSL port(s).
Note: A port must be enabled before data transmission can occur. An enabled but
disconnected ADSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port
when it is not in use.
Chapter 27 ADSL Commands
up/downstream profile
V auto 512/
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
9088 max
tel
-
AAM1212 User's Guide
199