Table of Contents
Advertisement
AAM1212 User's Guide
The following table describes the labels in this screen.
Table 47 Access Control: Logins
LABEL
Return
Administrator
This is the default administrator account with the "admin" user name. You cannot change the default
administrator user name.
Old Password
New Password
Retype to confirm
Apply
Cancel
19.3.6 Service Access Control Configuration
Click Advanced Application and Access Control from the navigation panel and then Service
Access Control from the Access Control screen to open the following screen. Use this screen
to set which services may be used to access the AAM.
Figure 76 Access Control: Service Access Control
The following table describes the labels in this screen.
Table 48 Access Control: Service Access Control
LABEL
Return
Services
Active
Server Port
148
DESCRIPTION
Click Return to go back to the previous screen.
Type the existing system password ("1234" is the default password when shipped).
Enter your new system password.
Retype your new system password for confirmation.
Click Apply to save your changes to the AAM's volatile memory. The AAM loses
these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Click Return to go back to the previous screen.
Services you may use to access the AAM are listed here.
Select the Active check boxes for the corresponding services that you want to
allow to access the AAM.
For Telnet, FTP or web services, you may change the default service port by typing
the new port number in the Server Port field. If you change the default port number
then you will have to let people (who wish to use the service) know the new port
number for that service.
Chapter 19 Access Control
Advertisement
Table of Contents
Troubleshooting
