Log Show Command; Figure 104 Time Server Set Command Example - ZyXEL Communications AAM1212 User Manual

where
[none]
<daytime|time|ntp
>
<ip>
<utc[<+|->
0100~1200]>
[nosync]
This command sets the AAM to use a time server.
The following example sets the AAM to use Daytime protocol to access a time server at IP
address 192.50.77.164 and sets the AAM's time zone to UTC.

Figure 104 Time Server Set Command Example

ras> sys timeserver set daytime 192.50.77.164 utc

26.2.18 Log Show Command

Syntax:
ras> sys log show
This command displays the system error log.
An example is shown next.
Chapter 26 Sys Commands
= This sets the system to not use a time server.
= The time service protocol.
Daytime (RFC 867) format is day/month/year/time
<daytime>
zone of the server.
Time (RFC-868) format displays a 4-byte integer
<time>
giving the total number of seconds since 1970/1/1 at 0:0:0.
NTP (RFC-1305) is similar to Time (RFC-868).
<ntp>
= The IP address of the time server.
= The time difference between UTC (Universal Time
Coordinated, formerly known as GMT, Greenwich Mean Time)
and your time zone.
= This sets the system to not synchronize with the time server
immediately after you press [Enter].
AAM1212 User's Guide
191