Adsl Loopback Command; Figure 114 Adsl Tel Command Example - ZyXEL Communications AAM1212 User Manual

AAM1212 User's Guide
where
<portlist>
<tel>
This command records the telephone number of an ADSL subscriber telephone number.
The following example records the telephone number "12345678" for ADSL port 5.

Figure 114 ADSL Tel Command Example

ras> adsl tel 5 12345678

27.3.10 ADSL Loopback Command

Syntax:
adsl loopback <portlist> <f5> <vpi> <vci>
where
<portlist>
<f5>
<vpi> <vci>
This command has the AAM perform a loopback test on the specified ADSL port(s).
The following example has the AAM perform a local loopback test on ADSL port 1.
204
= You can specify a single ADSL port <1>, all ADSL ports <*> or
a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
= An ADSL subscriber's telephone number.
= You can specify a single ADSL port <1>, all ADSL ports <*> or
a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
= Use f5 to perform an OAMF5 loopback test on the specified
DSL port. An Operational, Administration and Maintenance
Function 5 test is used to test the connection between two DSL
devices. First, the DSL devices establish a virtual circuit. Then
the local device sends an ATM F5 cell to be returned by the
remote DSL device (both DSL devices must support ATM F5 in
order to use this test).
= When you perform an OAMF5 loopback test, specify a VPI/
VCI.
Chapter 27 ADSL Commands