Ip Commands Summary; Figure 155 Ip Settings And Default Gateway Address; Table 62 Ip Commands - ZyXEL Communications AAM1212 User Manual

AAM1212 User's Guide
For example, use the following command sequence sets the AAM to have 192.168.1.3 as the
IP address, 255.255.255.0 for the subnet mask and 192.168.1.233 for the default gateway.
ras> ip set 192.168.1.3/24
ras> ip gateway 192.168.1.233
ras> config save

Figure 155 IP Settings and Default Gateway Address

The AAM leaves the factory with a default (in-band) management IP address of 192.168.1.1
and a subnet mask of 255.255.255.0, (ff:ff:ff:00 in hexadecimal notation), and the default
gateway set at 192.168.1.254. Make sure that you configure the IP parameters correctly before
you connect an AAM to the network, otherwise, you may interrupt services already running.

29.3 IP Commands Summary

The following table lists the

Table 62 IP Commands

COMMAND
ip
show
arp
set
gateway
route
244
commands you can use with the AAM.
ip
show
flush
<ip>[/
netmask]
<gateway ip>
show
set <dst ip>[/
netmask]
<gateway ip>
[metric] <name>
DESCRIPTION
Displays the management IP address
settings.
Displays the device's IP Address
Resolution Protocol status.
Clears the device's IP Address
Resolution Protocol status.
Sets the management IP address and
subnet mask.
Sets the IP address of the device's
default gateway.
Displays the routing table.
Adds a routing table entry.
Chapter 29 IP Commands