Data Rate; Configured Settings; Password; Snmp - ZyXEL Communications AAM1212 User Manual

33.7 Data Rate

The SYNC-rate is not the same as the configured rate.

Table 74 SYNC-rate Troubleshooting

STEPS
1
2

33.8 Configured Settings

The configured settings do not take effect.

Table 75 Configured Settings Troubleshooting

CORRECTIVE ACTION
Use the Config Save button or command after you finish configuring to save the AAM's settings.

33.9 Password

If you forget your password, you will need to use the console port to reload the factory-default
configuration file (see

33.10 SNMP

The SNMP manager server cannot get information from the AAM.

Table 76 SNMP Server Troubleshooting

STEPS
1
2
3
Chapter 33 Troubleshooting
CORRECTIVE ACTION
Connect the ADSL modem or router directly to the ADSL port using a different telephone
wire.
If the rates match, the quality of the telephone wiring that connects the subscriber to the
ADSL port may be limiting the speed to a certain rate.
If they do not match when a good wire is used, contact the distributor.
Section 33.13.1 on page
CORRECTIVE ACTION
Ping the AAM from the SNMP server. If you cannot, check the cable, connections and IP
configuration.
Check to see that the community (or trusted host) in the AAM matches the SNMP server's
community.
Make sure that your computer's IP address matches a configured trusted host IP address
(if configured).
AAM1212 User's Guide
273).
271