Static Entries (Svlan Table); Dynamic Entries (Dvlan Table); Ieee Vlan1Q Tagged Vlan Configuration Commands; Garp Timer Show Command - ZyXEL Communications AAM1212 User Manual

AAM1212 User's Guide

28.7.1 Static Entries (SVLAN Table)

Static entry registration information is added, modified and removed by administrators only.

28.7.2 Dynamic Entries (DVLAN Table)

Dynamic entries are learned by the AAM and cannot be created or updated by administrators.
The AAM learns this information by observing what port, source address and VLAN ID (or
VID) is associated with a frame. Entries are added and deleted using GARP VLAN
Registration Protocol (GVRP), where GARP is the Generic Attribute Registration Protocol.

28.8 IEEE VLAN1Q Tagged VLAN Configuration Commands

These switch commands allow you to configure and monitor the IEEE 802.1Q Tagged VLAN.

28.8.1 GARP Timer Show Command

Syntax:
ras> switch garptimer show
This command shows the AAM's GARP timer settings, including the join, leave and leave all
timers.
An example is shown next.

Figure 131 GARP Timer Show Command Example

ras> switch garptimer show
join time
leave time
leaveall time (ms): 10000

28.8.2 GARP Timer Join Command

Syntax:
ras> switch garptimer join <join msec>
where
<join msec>
226
(ms): 200
(ms): 600
= This sets the duration of the Join Period timer for GVRP in
milliseconds. Each port has a Join Period timer. The allowed
Join Time range is between 100 and 32767 milliseconds; the
default is 200 milliseconds.
Chapter 28 Switch Commands