Mac Filter Commands; Mac Filter Show Command; Figure 143 Vlan Show Command Example - ZyXEL Communications AAM1212 User Manual

This command shows information about the specified port's VLAN settings.
The following example shows the settings for all VIDs.

Figure 143 VLAN Show Command Example

ras> switch vlan show *
vid name
---- ---------------- ---------------------------------------------------
1 DEFAULT
enabled
2 test2
enabled
3 test3
enabled
200 test200
enabled

28.11 MAC Filter Commands

Use the MAC filter commands to allow only incoming frames from MAC (Media Access
Control) address(es) that you specify. MAC filter commands are listed next. You may specify
up to ten MAC addresses per port.

28.11.1 MAC Filter Show Command

Syntax:
switch mac filter show [portlist]
where
[portlist]
This command displays the MAC filtering status (V for enabled, - for disabled) and the fixed
source MAC addresses on the specified ADSL port(s) or on all ADSL ports if no port is
specified.
Chapter 28 Switch Commands
F:fixed X:forbidden N:normal
123456789012 12
FFFFFFFFFFFF FF
UUUUUUUUUUUU UU
123456789012 12
FXXXXXXXXXXX NN
U----------- TT
123456789012 12
FXXXXXXXXXXX NN
U----------- TT
123456789012 12
XXXXXXXXXXXX FN
------------ UT
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
AAM1212 User's Guide
U:untag T:tag
235