Line Diagnostics Set Command; Line Diagnostics Get Command; Figure 115 Adsl Profile Loopback Example; Figure 116 Adsl Line Diagnostics Set Command Example - ZyXEL Communications AAM1212 User Manual

Figure 115 ADSL Profile Loopback Example

ras> adsl loopback 1 f5 0 33
line 1 oam loopback success!

27.3.11 Line Diagnostics Set Command

Syntax:
adsl linediag setld <port number>
This command has the AAM perform line diagnostics on the specified port. The ADSL port
must be set to ADSL2 or ADSL2+ ADSL operational mode and have a connection. It takes
about one minute for the line diagnostics to finish.
The following example performs line diagnostics on ADSL port 1. The screen displays a
message confirming upon which ADSL port line diagnostics will be performed.

Figure 116 ADSL Line Diagnostics Set Command Example

ras> adsl linediag setld 1
Line- 1 set to Line Diagnostic Mode

27.3.12 Line Diagnostics Get Command

Syntax:
adsl linediag getld <port number>
Use this command to display the line diagnostics results after using the line diagnostics set
command on an ADSL port. Use the line diagnostics results to analyze problems with the
physical ADSL line.
Note: Wait at least one minute after using the line diagnostic set command before
using the line diagnostics set command.
The following example displays the line diagnostics results for ADSL port 1.
Chapter 27 ADSL Commands
AAM1212 User's Guide
205