Ip Commands; Chapter 52 Ip Commands; Ip Commands Introduction; Ip Settings And Default Gateway - ZyXEL Communications IES-1248-71 User Manual

C
H A P T E R
This chapter shows you how to use the (standard shell) IP commands to configure the IP
(Internet Protocol) parameters.

52.1 IP Commands Introduction

Use the IES-1248's management IP addresses to manage it through the network.

52.2 IP Settings and Default Gateway

Use the following command sequence to set the IES-1248's IP settings for the Ethernet 1 and
2, and DSL ports, VID and default gateway. With the Ethernet 1 and 2, and DSL ports, you
must connect to the IES-1248 through a port that is a member of the management (CPU)
VLAN in order to perform in-band management.

Figure 205 IP Settings and Default Gateway Address Commands

ras> ip set <new ip address> [</netmask>]
ras> ip gateway <ip>
ras> config save
where
<new ip
address>
</netmask>
<ip>
The first command changes the IP settings for the IES-1248's uplink, downlink and IES-1248
DSL ports. If you don't enter the subnet mask, the system automatically computes the subnet
mask.
IES-1248-71/73 User's Guide

IP Commands

The IP address you want to configure for the IES-1248.
=
The bit number of the subnet mask of the IP address you want to
=
configure for IES-1248's uplink, downlink and IES-1248 DSL
ports. To find the bit number, convert the subnet mask to binary
and add all of the 1's together. Take "255.255.255.0" for
example. 255 converts to eight 1's in binary. There are three
255's, so add three eights together and you get the bit number
(24).
The default gateway IP address you want to configure for the
=
IES-1248.
52
353