Sym MB10A7-A series Service Manual page 92

To this chapter contents
5. AC. Generator / Starting Clutch
Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Check the starter reduction gear and shaft for
any wear or damage.
Measure the inner diameter of starter
reduction gear.
Service limit：
Inner diameter：Under 13.02 mm
Measure the exterior diameter of starter
reduction gear shaft.
Service limit：
Exterior diameter：Over 12.96 mm
Starter clutch gear
tarter clutch inspection
S
Install the starter clutch gear onto the starter
clutch outer.
Hold the starter clutch and turn the starter
clutch gear.
Make sure the starter clutch gear can only be
turned counterclockwise.
Check the starter clutch gear for any wear or
damage.
Measure the exterior diameter of the starter
clutch gear.
Service limit：
Exterior diameter：over 35.91 mm
5-7