Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Do not let the wire harness contact with rotating,
moving or vibrating components when routing
the harness.
Keep wire harnesses far away from the hot parts.
Avoid wire harnesses from sharp edges or
corners, and also avoid the jutted-out ends of
bolts and screws.
Route harnesses so that they neither pull too
tight nor have excessive slack.
Never too
To this chapter contents
Never Touch
1. General Information
Protect wires or wire harnesses with electrical
tape or tube if they contact a sharp edge or
corner. Thoroughly clean the surface where tape
is to be applied.
Secure the rubber boot firmly as applying it on
wire harness.
Never use wires or harnesses which insulation
has been broken. Wrap electrical tape around
the damaged parts or replace them.
Never clamp or squeeze the wire harness when
installing other components.
Never clamp or
squeeze the
wire harness
1-7