Sym MB10A7-A series Service Manual page 70

Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Engine Oil
Turn off the engine, and park the motorcycle
on flat surface with main stand.
Check the oil level with the oil dipstick.
Do not screw the dipstick in while checking.
If oil level is low, fill into recommended oil to
reach the upper limit.
Engine oil replacement
Caution
Drain the engine oil when the engine is
fully warmed up, so the oil can be drained
out completely.
Place an oil basin under the bike, and remove
oil drain bolt.
After all oil is drained, make sure washer can
be re-used, and re-install oil drain bolt.
If the Oil drain bolt washer is damaged, it
should be replaced.
Torque value：1.5~2.5kgf-m
Oil Filter Screen Cleaning
Remove the oil filter screen cover (2 bolts).
Remove the oil filter screen.
Clean the oil filter screen with compressed air.
Check the cover washer and the oil filter
screen for any damage. Replace it with new
one if necessary.
Install the oil filter screen and the cover.
Torque value：0.8~1.2kgf-m
Fill in engine oil (oil viscosity SAE 10W-30)
Recommended using Bramax series oil.
Engine oil capacity: 800 c.c. Regular
exchange.
Install dipstick, run the engine for several
minutes. Then turn off the engine, and check
the oil level again.
Check if engine oil leaks.
To this chapter contents
4. Lubrication / Clutch / Transmission
Drain bolt
2 bolts
Upper
limit
Lower
limit
4-5