Sym MB10A7-A series Service Manual page 32

Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Lubrication System
Engine Oil Capacity
Caution
Turn off engine, and park the motorcycle
on flat surface with main stand.
Check oil level with oil dipstick. (Do not
screw the dipstick into engine when
checking.)
If oil level is near lower limit, fill in the
recommended engine oil to upper limit.
Engine Oil Replacement
Engine off and replace the oil dipstick.
Remove the oil drain bolt under the crankcase
to drain the engine oil.
After completely drain the engine oil, clean the
drain bolt and the washer. If the washer is
deformed or cracked, replace with a new one.
Torque value：3.5~4.5kgf-m
Caution
Warm up the engine before drain oil, that
will make engine oil easily drained
thoroughly
Fill in the engine oil to the standard capacity.
Oil viscosity SAE 10W-30 Recommended
using Bramax series engine oil.
Engine Oil Capacity
Full disassembly：1000 c.c.
Regular replacement：800 c.c.
Install the dipstick, run the engine for several
minutes. Turn off the engine, and check oil
level again. Check if engine oil leaks.
Engine Oil Strainer Cleaning
Drain engine oil completely.
Remove oil strainer.
Using high pressure air to clean oil strainer is
suggested.
Check if oil strainer is deformed or damaged.
Replace it if necessary.
Reinstall oil strainer and oil strainer cap.
Torque value：0.8~1.2kgf-m
To this chapter contents
2. Maintenance Information
Engine oil drain bolt
2 bolts
Upper limit
Lower limit
2-3