Sym MB10A7-A series Service Manual page 159

To this chapter contents
10. Steering / Front Wheel /Front Suspension / Front Brake Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Front cushion inspection / bearing
replacement
Scratch
Push the fork pipe for several times to check if
there is any oil leakage or excessive noise.
Check if there is any scratch on the fork pipe if
oil leakage happens.
Replace the front cushion if there is scratch on
the fork pipe.
Stopper ring
If there is oil leakage but without scratch on
the fork pipe, replace the oil seal.
Pour out the cushion oil.
Remove the oil seal stopper ring and then
remove the old oil seal.
Caution
Do not damage the fork pipe when
removing the oil seal.
Coat the inner side of the new oil seal with
cushion oil and then put in the fork pipe.
Stopper ring
Install the oil seal to the right position by using
an oil seal driver.
Clip the stopper ring.
Oil seal
Adjust the cushion oil capacity if the front
cushion is too hard or too soft.
Cushion oil：BRAMAX CUSHION OIL
Capacity：50 c.c.
10-14