Sym MB10A7-A series Service Manual page 100

Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Use a rack to hold the engine.
Remove the engine locknuts.
Pull out the engine holding bolts and remove
the engine.
Engine Installation
Install the engine in the reversed procedure of
removal
Caution
During installation, always pay attention
to the possible injuries.
All the wires and cables can't be bent or
pressed.
Please align the wires and cables in
accordance with the setting diagram.
Torque value：
Engine locknut (rear part of engine and
frame)
Step bar lock bolt
Left crankcase rear cover lock
bolt
Drive sprocket lock bolt
After installation and filling in engine oil, adjust
clutch free play, drive chain wave clearance
and idle speed.
To this chapter contents
3.0~3.5kgf-m
2.4~3.0kgf-m
0.8~1.2kgf-m
0.8~1.2kgf-m
6. Engine Removal
2 nuts
6-5