Smartport
Configuring Smartport Using The Web-based Interface
A second method of resetting single or multiple unknown interfaces is:
STEP 1
STEP 2
STEP 3
TIP
Configuring Smartport Using The Web-based Interface
The Smartport feature is configured in the Smartport > Properties, Smartport Type Settings and Interface
Settings pages.
For Voice VLAN configuration, see
For LLDP/CDP configuration, see the
Smartport Properties
To configure the Smartport feature globally:
STEP 1
STEP 2
•
Administrative Auto Smartport—Select to globally enable or disable Auto Smartport. The following
options are available:
-
Disable—Select to disable Auto Smartport on the device.
-
Enable—Select to enable Auto Smartport on the device.
Cisco Small Business 200 Series Smart Switch Administration Guide
In the Interface Settings page, select the Port Type equals to checkbox.
Select
Unknown
and click Go.
Click Reset All Unknown Smartports. Then reapply the macro as described above.
The reason that the macro failed might be a conflict with a configuration on the
interface made prior to applying the macro (most often encountered with security
and storm-control settings), a wrong port type, a typo or an incorrect command
within the user-defined macro, or an invalid parameter setting. Parameters are
checked for neither type nor boundary prior to the attempt to apply the macro,
therefore, an incorrect or invalid input to a parameter value will almost assuredly
cause failure when applying the macro.
Voice
VLAN.
Configuring LLDP
Click Smartport > Properties.
Enter the parameters.
and
Configuring CDP
12
sections, respectively.
155