Cisco Small Business 200 Series Administration Manual page 107

Administration: Discovery
Configuring CDP
- Serial Number—Use the serial number of the device as the device ID.
- Hostname—Use the host name of the device as the device ID.
• Source Interface—IP address to be used in the TLV of the frames. The following options are possible:
- Use Default—Use the IP address of the outgoing interface.
- User Defined—Use the IP address of the interface (in the Interface field) in the address TLV.
• Interface—IF User Defined was selected for Source Interface, select the interface.
• Syslog Voice VLAN Mismatch—Check to send a SYSLOG message when a voice VLAN mismatch is
detected. This means that the voice VLAN information in the incoming frame does not match what the
local device is advertising.
• Syslog Native VLAN Mismatch—Check to send a SYSLOG message when a native VLAN mismatch
is detected. This means that the native VLAN information in the incoming frame does not match what
the local device is advertising.
• Syslog Duplex Mismatch—Check to send a SYSLOG message when duplex information is
mismatched. This means that the duplex information in the incoming frame does not match what the
local device is advertising.
STEP 3
CDP Interface Settings
Use the Interface Settings page to activate LLDP and remote log server notification per port, and to select
the TLVs included in LLDP PDUs.
By setting these properties it is possible to select the types of information to be provided to devices that
support the LLDP protocol.
The LLDP-MED TLVs to be advertised can be selected in the LLDP MED Interface Settings page.
To define the CDP interface settings:
STEP 1
This page displays the following CDP information for each interface.
• CDP Status—CDP publishing option for the port.
• Reporting Conflicts with CDP Neighbors—Status of the reporting options that are enabled/disabled
in the Edit page (Voice VLAN/Native VLAN/Duplex).
Cisco Small Business 200 Series Smart Switch Administration Guide
Click Apply. The LLDP properties are defined.
Click Administration > Discovery - CDP > Interface Settings.
9
106