Defining Trap Settings - Cisco Small Business 200 Series Administration Manual

SNMP

Defining Trap Settings

• Basic—Select this mode for a selected community. In this mode, there is no connection to any group.
You can only choose the community access level (Read Only, Read Write, or SNMP Admin) and,
optionally, further qualify it for a specific view. By default, it applies to the entire MIB. If this is selected,
enter the following fields:
- Access Mode—Select the access rights of the community. The options are:
Read Only—Management access is restricted to read-only. Changes cannot be made to the
community.
Read Write—Management access is read-write. Changes can be made to the device
configuration, but not to the community.
SNMP Admin—User has access to all device configuration options, as well as permissions to
modify the community. SNMP Admin is equivalent to Read Write for all MIBs except for the SNMP
MIBs. SNMP Admin is required for access to the SNMP MIBs.
- View Name—Select an SNMP view (a collection of MIB subtrees to which access is granted).
• Advanced—Select this mode for a selected community.
- Group Name—Select an SNMP group that determines the access rights.
STEP 4
Defining Trap Settings
The Trap Settings page enables configuring whether SNMP notifications are sent from the device, and for
which cases. The recipients of the SNMP notifications can be configured in the Notification Recipients
SNMPv1,2 page, or the Notification Recipients SNMPv3 page.
To define trap settings:
STEP 1
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
Click Apply. The SNMP Community is defined, and the Running Configuration is
updated.
Click SNMP > Trap Settings.
Select Enable for SNMP Notifications to specify that the device can send SNMP
notifications.
Select Enable for Authentication Notifications to enable SNMP authentication
failure notification.
24
330