Administration: Discovery
Configuring CDP
To view the CDP neighbors information:
STEP 1
STEP 2
The filter is triggered, and Clear Filter is activated.
STEP 3
The CDP Neighbor Information page contains the following fields for the link partner (neighbor):
•
Device ID—Neighbors device ID.
•
System Name—Neighbors system name.
•
Local Interface—Number of the local port to which the neighbor is connected.
•
Advertisement Version—CDP protocol version.
•
Time to Live (sec)—Time interval (in seconds) after which the information for this neighbor is deleted.
•
Capabilities—Capabilities advertised by neighbor.
•
Platform—Information from Platform TLV of neighbor.
•
Neighbor Interface—Outgoing interface of the neighbor.
STEP 4
This page contains the following fields about the neighbor:
•
Device ID—Identifier of the neighboring device ID.
•
System Name—Name of the neighboring device ID.
•
Local Interface—Interface number of port through which frame arrived.
•
Advertisement Version—Version of CDP.
•
Time to Live—Time interval (in seconds) after which the information for this neighbor is deleted.
•
Capabilities—Primary functions of the device. The capabilities are indicated by two octets. Bits 0
through 7 indicate Other, Repeater, Bridge, WLAN AP, Router, Telephone, DOCSIS cable device, and
station respectively. Bits 8 through 15 are reserved.
•
Platform—Identifier of the neighbors platform.
•
Neighbor Interface—Interface number of the neighbor through which frame arrived.
•
Native VLAN—Neighbors native VLAN.
Cisco Small Business 200 Series Smart Switch Administration Guide
Click Administration > Discovery - CDP > CDP Neighbor Information.
To select a filter, check the Filter checkbox, select a Local interface, and click Go.
Click Clear Filter to stop the filter.
Select a device, and click Details.
9
110