Cisco Small Business 200 Series Administration Manual page 185

VLAN Management
Regular VLANs
The port mode for each port or LAG appears with its current port mode (Access, Trunk, General or
Customer) configured from the Interface Settings page.
Each port or LAG appears with its current registration to the VLAN.
STEP 3
• VLAN Mode—Type of ports in the VLAN.
• Membership Type:
- Forbidden—The interface is not allowed to join the VLAN. When a port is not a member of any
other VLAN, enabling this option on the port makes the port part of internal VLAN 4095 (a
reserved VID).
- Excluded—The interface is currently not a member of the VLAN. This is the default for all the ports
and LAGs when the VLAN is newly created.
- Tagged—The interface is a tagged member of the VLAN.
- Untagged—The interface is an untagged member of the VLAN. Frames of the VLAN are sent
untagged to the interface VLAN.
- PVID—Select to set the PVID of the interface to the VID of the VLAN. PVID is a per-port setting.
STEP 4
You can continue to display and/or configure port membership of another VLAN by selecting another VLAN
ID.
Port VLAN Membership
The Port VLAN Membership page displays all ports on the device along with a list of VLANs to which each
port belongs.
If the port-based authentication method for an interface is 802.1x and the Administrative Port Control is
Auto, then:
• Until the port is authenticated, it is excluded from all VLANs, except guest and unauthenticated ones.
In the VLAN to Port page, the port is marked with an upper case P.
• When the port is authenticated, it receives membership in the VLAN in which it was configured.
Cisco Small Business 200 Series Smart Switch Administration Guide
Change the registration of an interface to the VLAN by selecting its Interface
Name and selecting the desired option from the following list:
Click Apply. The interfaces are assigned to the VLAN
Configuration file.
14
written to the Running
, and
184