Cisco Small Business 200 Series Administration Manual page 243

Small business 200 series smart switch
Hide thumbs Also See for Small Business 200 Series:
Table of Contents

Advertisement

IP Configuration
Domain Name
All Dynamic & Static—Deletes the static and dynamic hosts.
The Host Mapping Table displays the following fields:
Host Name—User-defined host name or fully-qualified name.
IP Address—The host IP address.
IP Version—IP version of the host IP address.
Type—Is this a Dynamic or Static entry to the cache.
Status— Displays the results of attempts to access the host
OK
-
—Attempt succeeded.
Negative Cache
-
No Response
-
TTL (Sec)— If this is a dynamic entry, how long will it remain in the cache.
Remaining TTL (Sec)— If this is a dynamic entry, how much longer will it remain in the cache.
STEP 3
STEP 4
IP Version—Select Version 6 for IPv6 or Version 4 for IPv4.
IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The options are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single network link. A link local
address has a prefix of FE80, is not routable, and can be used for communication only on the local
network. Only one link local address is supported. If a link local address exists on the interface, this
entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and reachable from other
networks.
Link Local Interface—If the IPv6 address type is Link Local, select the interface through which it is
received.
Host Name—Enter a user-defined host name or fully-qualified name. Host names are restricted to the
ASCII letters A through Z (case-insensitive), the digits 0 through 9, the underscore and the hyphen. A
period (.) is used to separate labels.
IP Address—Enter a single address or up to eight associated IP addresses (IPv4 or IPv6).
STEP 5
Cisco Small Business 200 Series Smart Switch Administration Guide
—Attempt failed, do not try again.
—There was no response, but system can try again in future.
To add a host mapping, click Add.
Enter the parameters.
Click Apply. The settings are saved to the Running Configuration file.
18
242

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents