Multicast
IPv6 Multicast Configuration
-
User Defined—Enter a user-defined value.
STEP 4
STEP 5
STEP 6
NOTE
MLD VLAN Settings
To configure MLD on a specific VLAN:
STEP 1
The following fields are displayed for each VLAN on which is enabled:
•
Interface Name—VLAN for which MLD information is being displayed.
•
Router MLD Version—Version of MLD router.
•
Query Robustness—Enter the number of expected packet losses on a link
•
Query Interval (sec)—Interval between the General Queries to be used if this device is the elected
querier.
•
Query Max Response Interval (sec)—Delay used to calculate the Maximum Response Code
inserted into the periodic General Queries.
•
Last Member Query Interval (msec)—Enter the Maximum Response Delay to be used if the device
cannot read Max Response Time value from group-specific queries sent by the elected querier.
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
Select a VLAN, and click Edit.
Enter the parameters as described above.
Click Apply. The Running Configuration file is updated.
Changes in MLD Snooping timers configuration, such as: Query Robustness, Query
Interval etc. do not take effect on timers which were already created.
Click Multicast > IPv6 Multicast Configuration > MLD VLAN Settings.
To configure a VLAN, select it and click Edit. Enter the fields described above.
Click Apply. The Running Configuration file is updated.
17
219