Smartport Type Settings - Cisco Small Business 200 Series Administration Manual

Smartport
Configuring Smartport Using The Web-based Interface
- Enable by Auto Voice VLAN—This enables Auto Smartport, but puts it in operation only when Auto
Voice VLAN is also enabled and in operation. Enable by Auto Voice VLAN is the default.
• Operational Auto Smartport—Displays the Auto Smartport status.
• Auto Smartport Device Detection Method—Select whether incoming CDP, LLDP, or both types of
packets are used to detect the Smartport type of the attaching device(s). At least one must be
checked in order for Auto Smartport to identify devices.
• Operational CDP Status—Displays the operational status of CDP. Enable CDP if Auto Smartport is to
detect the Smartport type based on CDP advertisement.
• Operational LLDP Status—Displays the operational status of LLDP. Enable LLDP if Auto Smartport is
to detect the Smartport type based on LLDP/LLDP-MED advertisement.
• Auto Smartport Device Detection—Select each type of device for which Auto Smartport can assign
Smartport types to interfaces. If unchecked, Auto Smartport does not assign that Smartport type to
any interface.
STEP 3

Smartport Type Settings

Use the Smartport Type Settings page to edit the Smartport Type settings and view the Macro Source.
By default, each Smartport type is associated with a pair of built-in Smartport macros. See
Types for further information on macro versus anti-macro. Built-in or user-defined macros can have
parameters. The built-in macros have up to three parameters.
Editing these parameters for the Smartport types applied by Auto Smartport from the Smartport Type
Settings page configures the default values for these parameters. These defaults are used by Auto
Smartport.
NOTE
STEP 1
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
Click Apply. This sets the global Smartport parameters on the device.
Changes to Auto Smartport types cause the new settings to be applied to
interfaces which have already been assigned that type by Auto Smartport. In this
case, binding an invalid macro or setting an invalid default parameter value causes
all ports of this Smartport type to become unknown.
Click Smartport > Smartport Type Settings.
To view the Smartport macro associated with a Smartport type, select a
Smartport type and click View Macro Source.
To modify the parameters of a macro, select a Smartport type and click Edit.
12
Smartport
156