Cisco Small Business 200 Series Administration Manual page 41

Administration: File Management
Upgrade/Backup Firmware/Language
SSH Client Authentication—Client authentication can be done in one of the following ways:
• Use SSH Client System Credentials—Sets permanent SSH user credentials. Click System
Credentials to go to the SSH User Authentication page where the user/password can be set once for
all future use.
• Use SSH Client One-Time Credentials—Enter the following:
- Username—Enter a username for this copy action.
- Password—Enter a password for this copy.
The username and password for one-time credential will not saved in configuration file.
NOTE
Select one of the following Save Action(s):
• Upgrade—Specifies that the file type on the device is to be replaced with a new version of that file
type located on a TFTP server.
• Backup—Specifies that a copy of the file type is to be saved to a file on another device.
Enter the following fields:
• File Type—Select the destination file type. Only valid file types are shown. (The file types are
described in the
• SCP Server Definition—Select whether to specify the SCP server by IP address or by domain name.
• IP Version—Select whether an IPv4 or an IPv6 address is used.
• IPv6 Address Type—Select the IPv6 address type (if used). The options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A link local
address has a prefix of FE80, is not routable, and can be used for communication only on the local
network. Only one link local address is supported. If a link local address exists on the interface, this
entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPv6 type that is visible and reachable from other
networks.
• Link Local Interface—Select the link local interface from the list.
• SCP Server IP Address/Name—Enter the IP address or domain name of the SCP server.
• (For Upgrade) Source File Name—Enter the name of the source file.
• (For Backup) Destination File Name—Enter the name of the backup file.
STEP 6
Cisco Small Business 200 Series Smart Switch Administration Guide
Files and File Types
Click Apply. If the files, passwords and server addresses are correct, one of the
following may happen:
section).
5
40