Getting Started
This section provides an introduction to the web-based configuration utility, and covers the following topics:
•
Starting the Web-based Configuration Utility
•
Quick Start Device Configuration
•
Interface Naming Conventions
•
Window Navigation
Starting the Web-based Configuration Utility
This section describes how to navigate the web-based switch configuration utility.
If you are using a pop-up blocker, make sure it is disabled.
Browser Restrictions
If you are using IPv6 interfaces on your management station, use the IPv6 global address and not the IPv6
link local address to access the device from your browser.
Launching the Configuration Utility
To open the web-based configuration utility:
STEP 1
STEP 2
NOTE
Cisco Small Business 200 Series Smart Switch Administration Guide
Open a Web browser.
Enter the IP address of the device you are configuring in the address bar on the
browser, and then press Enter.
When the device is using the factory default IP address of 192.168.1.254, its power
LED flashes continuously. When the device is using a DHCP-assigned IP address or
an administrator-configured static IP address, the power LED is on solid.
2
8