Port Configuration - Cisco Small Business 200 Series Administration Manual

Port Management
Configuring Ports
7. If PoE is supported and enabled for the device, configure the device as described in
PoE.

Port Configuration

Ports can be configured in the following pages.
Port Settings
The Port Settings page displays the global and per port setting of all the ports. This page enables you to
select and configure the desired ports from the Edit Port Settings page.
To configure port settings:
STEP 1
STEP 2
STEP 3
Jumbo frames configuration changes take effect only after the Running Configuration is explicitly saved to
the Startup Configuration File using the Copy/Save Configuration page, and the device is rebooted.
STEP 4
STEP 5
• Interface—Select the port number.
• Port Description—Enter the port user-defined name or comment.
• Port Type—Displays the port type and speed. The possible options are:
- Copper Ports—Regular, not Combo, support the following values: 10M, 100M, and 1000M (type:
Copper).
- Combo Ports Copper—Combo port connected with copper CAT5 cable, supports the following
values: 10M, 100M, and 1000M (type: ComboC).
- Combo Fiber—SFP Fiber Gigabit Interface Converter Port with the following values: 100M and
1000M (type: ComboF).
- 10G-Fiber Optics—Ports with speed of either 1G or 10G.
SFP Fiber takes precedence in Combo ports when both ports are being used.
NOTE
Cisco Small Business 200 Series Smart Switch Administration Guide
Click Port Management > Port Settings.
Select Jumbo Frames to support packets of up to 10 Kb in size. If Jumbo Frames
is not enabled (default), the system supports packet size up to 2,000 bytes. For
jumbo frames to take effect, the device must be rebooted after the feature is
enabled.
Click Apply to update the global setting.
To update the port settings, select the desired port, and click Edit.
Modify the following parameters:
10
Port Management:
114