Dynamic Mac Addresses - Cisco Small Business 200 Series Administration Manual

Managing MAC Address Tables

Dynamic MAC Addresses

Dynamic MAC Addresses
The Dynamic Address Table (bridging table) contains the MAC addresses acquired by monitoring the
source addresses of frames entering the device.
To prevent this table from overflowing and to make room for new MAC addresses, an address is deleted if
no corresponding traffic is received for a certain period of time known as the aging time.
Configuring Dynamic MAC Address Aging Time
To configure the aging time for dynamic addresses:
STEP 1
STEP 2
STEP 3
Querying Dynamic Addresses
To query dynamic addresses:
STEP 1
STEP 2
• VLAN ID—Enter the VLAN ID for which the table is queried.
• MAC Address—Enter the MAC address for which the table is queried.
• Interface—Select the interface for which the table is queried. The query can search for specific unit/
slot, ports, or LAGs.
STEP 3
To delete all of the dynamic MAC addresses. click Clear Table.
-
STEP 4
Cisco Small Business 200 Series Smart Switch Administration Guide
Click MAC Address Tables > Dynamic Address Settings.
Enter Aging Time. The aging time is a value between the user-configured value
and twice that value minus 1. For example, if you entered 300 seconds, the aging
time is between 300 and 599 seconds.
Click Apply. The aging time is updated.
Click MAC Address Tables > Dynamic Addresses.
In the Filter block, you can enter the following query criteria:
Click Go. The Dynamic MAC Address Table is queried and the results are
displayed.
16
207