Configuring Smartport Using The Web-Based Interface; Smartport Properties - Cisco 300 Series Administration Manual

11
STEP 1
STEP 2
STEP 3
TIP

Configuring Smartport Using The Web-based Interface

STEP 1
STEP 2
170
A second method of resetting single or multiple unknown interfaces is:
In the Interface Settings page, select the Port Type equals to checkbox.
Select Unknown and click Go.
Click Reset All Unknown Smartports. Then reapply the macro as described above.
The reason that the macro failed might be a conflict with a configuration on the
interface made prior to applying the macro (most often encountered with security
and storm-control settings), a wrong port type, a typo or an incorrect command
within the user-defined macro, or an invalid parameter setting. Parameters are
checked for neither type nor boundary prior to the attempt to apply the macro,
therefore, an incorrect or invalid input to a parameter value will almost assuredly
cause failure when applying the macro.
The Smartport feature is configured in the Smartport > Properties, Smartport
Type Settings and Interface Settings pages.
For Voice VLAN configuration, see
For LLDP/CDP configuration, see the
sections, respectively.

Smartport Properties

To configure the Smartport feature globally:
Click Smartport > Properties.
Enter the parameters.
• Administrative Auto Smartport—Select to globally enable or disable Auto
Smartport. The following options are available:
- Disable—Select to disable Auto Smartport on the device.
- Enable—Select to enable Auto Smartport on the device.
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
Configuring Smartport Using The Web-based Interface
Voice VLAN.
Configuring LLDP
Smartport
and Configuring CDP