Cisco Small Business 200 Series Administration Manual page 218

Multicast
IPv4 Multicast Configuration
STEP 5
STEP 6
NOTE
IGMP VLAN Settings
To configure IGMP on a specific VLAN:
STEP 1
The following fields are displayed for each VLAN on which IGMP is enabled:
• Interface Name—VLAN on which IGMP snooping is defined.
• Router IGMP Version—Version of IGMP Snooping.
• Query Robustness—Enter the number of expected packet losses on a link.
• Query Interval (sec)—Interval between the General Queries to be used if this device is the elected
querier.
• Query Max Response Interval (sec)—Delay used to calculate the Maximum Response Code
inserted into the periodic General Queries.
• Last Member Query Interval (msec)—Enter the Maximum Response Delay to be used if the device
cannot read Max Response Time value from group-specific queries sent by the elected querier.
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
Enter the parameters as described above.
Click Apply. The Running Configuration file is updated.
Changes in IGMP Snooping timers configuration, such as: Query Robustness,
Query Interval etc. do not take effect on timers which were already created.
Click Multicast > IPv4 Multicast Configuration > IGMP VLAN Settings.
Select an interface, and click Edit. Enter the values of the fields described above.
Click Apply. The Running Configuration file is updated.
17
217