Cisco Small Business 200 Series Administration Manual page 192

VLAN Management
Voice VLAN
Voice VLAN Workflows
The device default configuration on Auto Voice VLAN, Auto Smartports, CDP, and LLDP cover most
common voice deployment scenarios. This section describes how to deploy voice VLAN when the default
configuration does not apply.
Workflow1: To configure Auto Voice VLAN:
STEP 1
STEP 2
STEP 3
STEP 4
If the device is currently in Telephony OUI mode, you must disable it before you can configure
NOTE
Auto Voice Vlan
STEP 5
STEP 6
STEP 7
STEP 8
Step 7 and Step 8 are optional as they are enabled by default.
NOTE
Workflow2: To configure the Telephony OUI Method
STEP 1
If the device is currently in Auto Voice VLAN mode, you must disable it before you can enable
NOTE
Telephony OUI.
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
Open the VLAN Management > Voice VLAN > Properties page.
Select the Voice VLAN ID. It cannot be set to VLAN ID 1 (this step is not required for
dynamic Voice VLAN).
Set Dynamic Voice VLAN to Enable Auto Voice VLAN.
Select the Auto Voice VLAN Activation method.
Click Apply.
Configure Smartports as described in the
Configure LLDP/CDP as described in the
CDP sections, respectively.
Enable the Smartport feature on the relevant ports using the Smartport > Interface
Settings page.
Open the VLAN Management > Voice VLAN > Properties page. Set Dynamic Voice
VLAN to Enable Telephony OUI.
Configure Telephony OUI in the Telephony OUI page.
Configure Telephony OUI VLAN membership for ports in the Telephony OUI
Interface page.
Common Smartport Tasks
Configuring LLDP and
14
section.
Configuring
191