381.31 Sensor (booklet front tamper HP) lag jam
Step
Action and questions
Check the booklet unit interface
1
connector assembly.
Is the above component free of
damage?
Check the main connector on the
2
booklet unit sensor interface
cable assembly.
Is the above component free of
damage?
Check the main connector on the
3
booklet unit motor interface cable
assembly.
Is the above component free of
damage?
Check the booklet front tamper by
4
moving it manually.
Does the above component
slide back and forth properly?
Check the sensor (booklet front
5
tamper HP) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (booklet front
tamper HP.
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
6
Is the sensor (booklet front
tamper HP) properly
connected?
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
Go to step 7.
Replace the sensor (booklet front
tamper HP). Go to
"Sensor
(booklet front tamper HP)
removal" on page
4-386.
7558-xxx
No
Replace the booklet unit interface
contact.
Replace the booklet sensor
interface cable assembly.
Replace the booklet motor
interface cable assembly.
Remove obstructions.
Go to step 6.
Replace the connection.
Diagnostic information
Previous
Next
Go Back
2-203