Change History - Lexmark X95x Series Service Manual

Change history

Revision date
2014/11/20
2014/10/10
2014/09/05
2014/08/12
2014/05/05
2014/01/10
2013/12/05
2013/11/4
2013/10/21
2013/10/7
2013/9/4
2013/08/01
2013/07/11
2013/04/26
2013/02/25
2012/08/15
2012/08/01
2012/07/02
Updates
Added scanner calibration information in the
Removed the Registration topic from the Diagnostic aids chapter.
• Updated the 121.04, 121.06, and 121.08 service checks in the Diagnostics information
chapter.
• Added PN 40X6091 in the parts catalog.
Parts catalog assembly 9—Deleted part numbers 40X6973 and 40X6307, and replaced
them with 40X9241.
• Updated
"Booklet maker 2" on page
art and table.
• Updated
"Finisher—electronics" on page
the art and table.
Changed PN 40X0727 to 40X6676 for the Sensor (Tray module feedout) in Assembly 37:
TTM media feed 2 of the parts catalog.
• Updated description for error code 121.12 to "Fuser failure" from "Incorrect fuser."
• Updated the action description to "Wrong fuser is possibly installed or fuser drive PCBA
has failed" from "Wrong fuser is installed."
• Updated
"121.12 Fuser failure" on page
Parts catalog Assembly 55: Changed P/N to 40X7464 to 40X6726.
Parts catalog Assembly 37:
• Updated description of 40X7334
• Added 40X0588 and 40x0727
• Deleted 40X7336, 40X7337, and 40X7338
Replaced 40X7511 with 40X7512 in Parts catalog Assembly 108.
Replaced 40X0727 with 40X7334 in the Parts catalog Assembly 37.
• Updated Parts catalog Assembly 37.
• Added "Steps before starting the 9yy service checks".
• Updated the Bridge PCBA (MFP) part number.
• Added the following error codes and service checks: 146, 324, 334, 344, and 354.
• Updated Assembly 62 to show the proper orientation of the parts catalog illustration.
• Added the rear lower cover removal procedure before the step "Disconnect the input
option cable (A)" in the repair chapter.
Updated Assembly 18 of the parts catalog to the show proper order of the augers.
Replaced part number 40X7421 to 40X8663 in
of the parts catalog.
Updaed the Bridge PCBA (MFP) part number in
catalog.
Added part number 40X0580 in
and
"Tray module media feed" on page 7-31
"Diagnostics Menu" on page
7-87, removed the booklet controller card in the
7-84, added the booklet controller card in
2-62.
"Finisher—stacker bin lift" on page 7-73
"Electrical 1" on page 7-57
"Media feed 1" on page 7-27,
in the parts catalog.
7558-xxx
3-17.
of the parts
"TTM trays" on page 7-36,
Preface
xxxi
Previous
Next
Go Back