Sensor (Mpf Feed Out) Lag Jam - Lexmark X95x Series Service Manual

Step Action and questions
Check the the HCF controller
9
card PCBA for proper connection.
Is the above component
properly connected?
POR the machine, and perform a
10
print test. Go to
"PRINT TESTS"
on page 3-26.
Does the error continue?

250.05 Sensor (MPF feed out) lag jam

Step Action and questions
Check the media path.
1
Is the media path free of any
media fragments?
Check the MPF rollers for wear.
2
Is the MPF feed/pick roller
assembly free of excess wear?
Check the sensor (MPF feed out)
3
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch PRINTER SENSOR
TESTS.
4. Touch Sensor (MPF feed
out).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (MPF feed out)
4
for proper connection.
Is the above component
properly connected?
Yes
Replace the HCF controller card
PCBA. Go to
"HCF controller
card PCBA removal" on
page 4-432.
Go to step 10.
Replace the upper printer engine
PCBA.
Go to
"Upper printer engine
PCBA removal" on page 4-189.
Yes
Go to step 2.
Go to step 3.
Go to step 5.
Replace the sensor (MPF feed
out). Go to
"MPF tray feeder
removal" on page 4-131.
7558-xxx
No
Replace the connections.
Problem resolved
No
Remove any media or media
fragments.
Replace the MPF feed roller. Go
to
"MPF roller removal" on
page 4-130.
Go to step 4.
Diagnostic information
Previous
Next
Go Back
2-135