Sensor (Stacker Bin No Media) Error - Lexmark X95x Series Service Manual

Step Action and questions
Check the stacker bin lift motor
8
for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Stacker bin lift motor
(up).
5. Touch Stacker bin lift motor
(down).
Does the above component
operate properly?
9 Is the stacker bin lift motor
connected properly?
Perform a POR.
10
Does the error continue when
the power is turned off/on?

381.14 Sensor (stacker bin no media) error

Step Action and questions
Check the media stacker bin
1
actuator for proper operation.
Is the media stacker bin
actuator installed properly?
Does it enter the sensing area
of the sensor (stacker bin
upper limit)?
Check the sensor (stacker bin no
2
media) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (stacker bin
no media).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Yes
Go to step 10.
Replace the stacker bin lift motor.
Go to
"Stacker bin lift motor
assembly removal" on
page 4-410.
Replace the finisher controller
PCBA. Go to
"Finisher PCBA
removal" on page 4-356.
Yes
Go to step 2.
Go to step 4.
7558-xxx
No
Go to step 9.
Replace the connection.
Problem resolved
No
Repair the media stacker bin
actuator.
Go to step 3.
Diagnostic information
Previous
Next
Go Back
2-191