Sensor (Adf Registration) Lag Jam - Lexmark X95x Series Service Manual

Step Action and questions
Place an undamaged document
8
in the ADF, and perform an ADF
test.
Does the error remain?

283.05 Sensor (ADF registration) lag jam

Step Action and questions
Check the media path.
1
Is the media path free of any
media or media fragments?
Check the ADF rollers for wear.
2
Is the ADF feed/pick roller
assembly or the ADF
separation roller guide free of
excess wear?
Check the ADF inverter.
3
Is the inverter gate free of
damage and warpage, and
does it move smoothly?
Check the sensor (ADF pre
4
registration) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch ADF/SCANNER
SENSOR TESTS.
4. Touch Sensor (ADF
registration).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (ADF
5
registration) for proper
connection.
Is the above component
properly connected?
Yes
Replace the ADF controller
PCBA. Go to
"ADF controller
PCBA removal" on page 4-206.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 6.
Replace the sensor (ADF
registration). Go to
"Sensor
(ADF registration) removal" on
page 4-250.
7558-xxx
No
Problem resolved
No
Remove any media or media
fragments.
Replace the ADF feed/pick roller
assembly. Go to
"ADF feed/pick
roller assembly removal" on
page 4-213.
Replace the ADF sensor actuator
guide. Go to
"ADF sensor
actuator guide removal" on
page 4-225.
Go to step 5.
Replace the connections.
Diagnostic information
Previous
Next
Go Back
2-151