Copier Network Settings - Konica Minolta Image Controller IC-402 User Manual

Copier Network Functions
6 Copier Network Functions
6.1

Copier Network Settings

This section describes the copier network functions.
- The image controller is equipped with two network ports. One port is
used to connect the image controller to the network port on the copier
with a network cable (cross cable). The other network port is used to con-
nect the image controller to an external LAN. (Refer to figure 1.)
- The network settings are saved in the image controller, which uses them
to communicate with the external LAN. The network settings saved in the
copier are used by it to communicate with the external LAN through the
network card in the image controller.
- The image controller and the copier each have their own network func-
tions. The image controller mainly has network scan functions and net-
work print functions. However, the copier has various other functions,
such as a function for sending a notification by e-mail about the copier's
status and a function for performing an LDAP search for an address when
specifying an e-mail address. (Refer to table 1.)
- Various settings must be specified on the image controller and copier in
order for their corresponding functions to be available. The image con-
troller settings are specified from the setup screen of the image controller
(refer to page 5-4, and the copier settings are specified from the copier's
Administrator Setting screen.*1 Details on the copier settings are de-
scribed in this chapter.
*1 In order to use some image controller functions, some settings may
need to be specified from the copier.
IC-402
6
6-2