Replacing Complete Rear Light; System); Replacing Rear Lamp Holder - (Conventional Lighting System); Seating - Invacare TDX SP2 Service Manual

5.
Remove two protection caps (5).
6. Loosen and remove two nuts (4) / (3) including washers
(2) and protection caps (1).
7. Replace rear light.
Installing rear light
1. Install parts in reverse order.
2. Test all functions.
6.8.9 Replacing complete rear light - (LED lighting system)
• 4 mm Allen key
• 13 mm socket wrench
Removing rear light
1. Remove rear shroud as described in 6.6.2 Removing rear
shroud, page 30.
2. Carefully note location of cable and connection locations
of various plugs. Either mark each plug and socket, or
take a photograph with a digital camera.
3.
Illustration shows lighting PCB B for power module C,
the optional cross connector D.
4. Loosen cable leading to lighting PCB from rear light
affected.
5. Remove all cable ties and pull cable out of wheelchair.
6.
Loosen wing nut (2).
7. Remove glass (1).
1532486-L
8.
Open connector plug (3) for the rear light which needs
to be replaced.
9. The rear lights are only clamped in by the plastic
housing. If required, replace the red rear light (2) or the
indicator (1). The cables are labelled appropriately.
Install rear light
1. Install parts in reverse order.
2. Tighten all screws finger-tight again.
3. Test all functions.
6.8.10 Replacing rear lamp holder - (conventional lighting

system)

• Size 2 Phillips screwdriver
• 8 mm socket wrench
• 3/16" Allen key
Removing rear lamp holder
1. Remove complete rear light as described in 6.8.8
Replacing rear light complete - (conventional lighting
system) , page 40.
2. Loosen and remove two screws (2) on chassis including
washers.
3. Replace lamp holder (1).
Installing rear lamp holder
1. Install parts in reverse order.
2. Test all functions.

6.9 Seating

• For seat systems —Modulite and ULM, refer to the
corresponding manual.
• Older specifications have been described in revision 11
of this service manual.
Service
41