8-44 CHASSIS
CUSHION LEVER BEARING
Insert the spacer into bearing and check the play to move the
spacer up and down. If an excessive play is noted, replace the
bearing with a new ones.
• Remove the cushion rod lower side bearings by with the spe-
cial tool.
09921-20240: Bearing remover set (17 mm)
The removed bearings must be replaced with new
ones.
• Remove the cushion lever mounting bearing 2 and shock
absorber lower side bearing 3 by using the special tool.
09913-70210: Bearing installer set
The removed bearings must be replaced with new
ones.
SHOCK ABSORBER
Inspect the shock absorber body and bush for damage and oil
leakage. If any defects are found, replace the shock absorber
with a new one.
Do not attempt to disassemble the rear shock
absorber unit. It is unserviceable.