Suzuki VZ800 Service Manual page 25

• Remove all the inspection caps.
• Remove all the spark plugs.
• Remove the generator cover plug 4.
• Remove the cap 5 and the timing inspection plug 6.
• Rotate the generator rotor to set the No. 1 engine's piston at
TDC of the compression stroke. (Rotate the rotor until the "R I
T" line on the rotor is aligned with the center of hole on the
generator cover.)
• To inspect the No. 1 engine's valve clearance, insert the thick-
ness gauge to the clearance between the valve stem end and
the adjusting screw on the rocker arms.
 09900-20806: Thickness gauge
• If the clearance is out of the specification, bring it into the
specified range by using the special tool.
 09917-10410: Valve adjust driver
PERIODIC MAINTENANCE 2-9
R T