4-22 SHAFT DRIVE
• Install the needle roller bearing for the final driven bevel gear
into the final gear case with the special tool.
09913-76010: Bearing installer
NOTE:
The boss on the bearing end should face to the driven bevel
gear side.
• Install the bearing retainer. Apply a small quantity of the
THREAD LOCK on the screws, and tighten them to the speci-
fied torque.
99000-32050: THREAD LOCK "1342"
Bearing retainer screw: 9 N·m (0.9 kgf-m, 6.5 lb-ft)
• Install a new oil seal to the final gear bearing case.
• Apply grease to the lip of the oil seal.
99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)
• Apply SUZUKI BOND to the mating surface of the final gear
case and final gear bearing case.
Do not block the breather passage when applying
SUZUKI BOND.
99000-31140: SUZUKI BOND "1207B"
• Apply THREAD LOCK to the final gear case bolts and tighten
them to the specified torque.
Final gear case bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
99000-32050: THREAD LOCK "1342"