Suzuki VZ800 Service Manual page 128

3-82 ENGINE
• Align the arrow marks on the front and rear camshafts so it is
parallel with the surface of the cylinder heads.
NOTE:
Arrow marks are located to forward.
• Engage the chains on the cam sprockets with the locating pin
holes A as shown in the photograph.
NOTE:
Do not rotate the generator rotor while doing this. When the
sprocket is not positioned correctly, turn the sprocket.
• Recheck the position of the "R I T" mark on the generator
rotor, arrow mark on the No. 1 (Rear) camshaft and arrow
mark on the No. 2 (Front) camshaft.
• Install the lock washer so that it is covering the locating pin.
• Apply THREAD LOCK SUPER "1303" to the bolts and tighten
them to the specified torque.
 Cam chain sprocket bolt: 15 N·m (1.5 kgf-m, 11.0 lb-ft)
 99000-32030: THREAD LOCK SUPER "1303"
• Bend up the washer tongue positively to lock the bolts.
CYLINDER HEAD COVER
• Clean the mating surfaces of the cylinder head and head
cover before matching.
• Install the dowel pins to the cylinder head.
Front
Camshaft
Bend up
Bolt
Pin
Washer
Sprocket
Front